Adding New Modules To The System; Viewing All Modules In The System - AMX MAX-HT04 Operation/Reference Manual

MAX Admin Menu
MAX-HT Home Theater Servers treat MAX-AVP Audio-Video Players exactly the
same as MAX-AVP modules, and the process of adding AVPs is the same as that for
AVPs.

Adding New Modules to the System

1. Select Add, then select the type of module (MAX-AOM or MAX-AVM) you are adding (FIG. 12).
FIG. 12 Add Output Module
If you are adding a MAX-AVP, select AVM from the Add Output Module menu.
2. Click OK to proceed. Next you must enter an Output Number for the new module (FIG. 13).
FIG. 13 Add Output Module (
Click OK to save your changes.

Viewing all Modules in the System

Select View in the Output Module Setup page (FIG. 11 on page 17) to open a read-only list of all
modules currently detected by the server to be installed in the system (FIG. 14).
FIG. 14 Installed Output Modules
18
AOM AVM
and
MAX-HT04 and -HT12 Home Theater servers support up to two AOM modules, so the output
can be either 1 or 2. If you are only using one AOM with these servers, the output should be
set to 1.
If you are adding a MAX-AVM audio-video module, the range is 1-25.
If you are adding a MAX-AVP Audio-Video Player, the range is 1-25 (MAX-HT04 and
MAX-HT12 servers support up to a total of 25 AVMs and/or AVPs).
)
MAX HT Servers