Rack Mounting MAX Servers
Rack Mounting HT Servers
Each MAX-HT Server comes with a Rack-Mounting Kit. Each Rack-Mounting Kit supports one server
and includes all hardware required to mount HT Servers in a standard 19-inch (48-cm) equipment rack.
The parts included in the Kit include:
Extension Brackets (2)
Screws: 10 round head, 10 flat head, 10 locking nuts
FIG. 41
Included Rack Kit Parts
You may not need all the parts included in the kit for every installation.
Before you begin, disassemble the Slide Rail Assemblies: the Stationary, Intermediate and Chassis
sections must be separated before they can be attached to the server and rack.
Step 1: Install Chassis Sections Onto The Server Chassis
The Chassis Sections mount directly to the server chassis, using the middle row of screws on the server
chassis.
The server has plastic plugs in the holes that you will use to attach the Chassis Sections, to keep the
server chassis sealed in case the server is not rack-mounted.
To see how these parts will mount, visually align the Chassis Sections with the middle row of plugs on
each side of the server, so that the four screw holes on the Chassis Section rail align with the middle row
of plugs on the server.
Make sure to orient the Chassis Sections so that the locking tab button is facing
outwards, and located toward the rear of the server.
42
2 Slide Rail Assemblies (each consists of a Stationary section, an Intermediate section and a
Chassis section; pre-assembled for shipping)
2 Extension Brackets
2 End Brackets
6 Locking Plates (4-hole) - not required
4 Adapter Bars (9-hole)
10 flat-head screws, 10 round-head screws
INTERMEDIATE SECTION (2)
STATIONARY SECTION (2)
CHASSIS SECTION (2)
End Brackets (2)
Locking Tab Hole
Locking Release Tab
Locking Plates (6)
Adapter Bars (4)
MAX HT Servers