Step 4: Mount The Adapter Bars To The Rack-Rail Assemblies - AMX MAX-HT04 Operation/Reference Manual

Step 4: Mount the Adapter Bars to the Rack-Rail assemblies

1. Use the included mounting hardware to attach an Adapter Bar to the front and rear of each of the
two Rack-Rail assemblies:
To ensure a proper fit, make sure that each Adapter Bar is mounted flush against all sides of the tabs
on the Rack-Rail assembly. When the Adapter Bar is seated properly against the tabs on the front of
the Rack-Rails, the bottom of the Adapter Bar should be flush with the bottom of the Rack-Rail
(FIG. 45).
The bottom of the Adapter Bar sits flush against the tabs on the Rack-Rail assembly
Use these holes to mount the Adapter
FIG. 45 Adapter Bar mounted to the front of the Rack-Rail assembly
2. Attach an Adapter Bar to the rear of each of the two Rack-Rail assemblies (FIG. 46). Once the
Adapter Bars have been attached to the front and rear of both Rack-Rail assemblies, the Rack-Rails
are ready to use.
(front)
FIG. 46 Mount the Adapter Bars to the Rail assemblies
MAX HT Servers
FRONT VIEW
Bar to the Rack-Rails
Mounting rails on equipment rack
Adapter Bar
Rail Assembly
Rack Mounting MAX Servers
REAR VIEW
Use the outside and center holes to mount
the Rack-Rail w/ Adapter Bars to
the equipment rack
Adapter Bar
(rear)
45