Max Ht Servers - Setup And Configuration; Overview; Networking Specifications For Max Servers - AMX MAX-HT04 Operation/Reference Manual

MAX HT Servers - Setup and Configuration

Overview

The following sections describe the basic process of setting up a MAX Server and making the
configurations required to get the MAX-HT Server up and running with one or more MAX-AVP Audio/
Video Players and/or MAX-AVM Audio/Video Modules and MAX-AOM Audio-Only (USB) modules.
MAX-HT Servers support the AVM and AOM modules as well as MAX-AVP Audio/Video Players.
Since the HT Servers treat AVPs exactly the same as AVMs, each HT Server supports up to a total of 25
AVPs/AVMs.
Use the WinMAX software to add/remove content on the MAX Server, as well as
control playback and configure the server. Additional documentation, including the
WinMAX Software Instruction Manual and the MAX by AMX Reference Guide are
available online at www.amx.com.
These steps apply to all MAX servers, unless otherwise noted.
Refer to the Product Specifications section for each server to establish the location
and orientation of the connectors mentioned in these steps.

Networking Specifications for MAX Servers

It is required that the control segment of the network (using the ETHERNET CONTROL
connector) is kept separated from the (switched) content delivery segment (using the A/V OUT
connector), as indicated in FIG. 3.
FIG. 3 Network Segment Layout
MAX HT Servers
MAX HT Servers - Setup and Configuration
5