Step 3: Attach The Extension Brackets - AMX MAX-HT04 Operation/Reference Manual

Rack Mounting MAX Servers

Step 3: Attach the Extension Brackets

With the Intermediate and Stationary Sections together, you can now attach the Extension Brackets. The
Extension Brackets attach to the rear end of the Stationary Section, and allow the Rail Assembly to be
anchored to the rear of the equipment rack.
Note that the Extension Brackets are designed to accommodate a range of depths. Attach the brackets to
the Rail Assemblies so that the rear mounting tabs reach the rear of the equipment rack, while the front
mounting tabs reach the front of the rack.
1. Measure (or estimate) the depth required by your equipment rack, to get an idea of how far forward
or back the Extension Bracket should be mounted on the Rail Assemblies.
Depending on the space required, you may choose to use the End Brackets rather than the Extension
Brackets.
2. Loosely mount the Extension Brackets to the Rail Assemblies, using the (included) round-head
screws, as shown in FIG. 44.
(front)
Mounting tabs
(on the front of the rail assembly
Secure to the front rails on
the equipment rack
FIG. 44 Attach the Extension Brackets to the Stationary/Intermediate Sections
44
Do not tighten the screws until the assembly is mounted into the rack.
Stationary Section/Intermediate
Section Rail Assembly
Secure to the rear rails on the equipment rack
Verify that the mounting tabs on the Rail Assemblies and the Extension brackets are facing the
same direction. The mounting tabs are used to secure the assembly to the vertical mounting
rails on the equipment rack.
Extension Bracket
Mounting tabs (rear)
(rear)
MAX HT Servers