GREAT PLANES Waco YMF-5 Instruction Manual page 39

One final note about flying your model. Have a goal or flight
plan in mind for every flight. This can be learning a new
maneuver(s), improving a maneuver(s) you already know,
or learning how the model behaves in certain conditions
(such as on high or low rates). This is not necessarily to
improve your skills (though it is never a bad idea!), but more
importantly so you do not surprise yourself by impulsively
attempting a maneuver and suddenly finding that you've run
out of time, altitude, or airspeed. Every maneuver should be
deliberate, not impulsive. For example, if you're going to do a
loop, check your altitude, mind the wind direction (anticipating
rudder corrections that will be required to maintain heading),
remember to throttle back at the top, and make certain you
are on the desired rates (high/low rates). A flight plan greatly
reduces the chances of crashing your model just because
of poor planning and impulsive moves. Remember to think.
Have a ball!
But always stay in control and fly in a safe manner.
GOOD LUCK AND GREAT FLYING!
FRONT COCKPIT DOOR
TEMPLATE
Note: Door is only on left side, front cockpit.
1. Stick this page to some
card stock or thin cardboard.
2. Cut out along these lines.
3. Using the pictures on the box as a guide,
Tape in place and trace panel lines onto
fuselage using a Top Flite panel line pen.
39
IGNITION SWITCH AND ERNST
CHARGE JACK TEMPLATE
FUTM4370
HCAM2400
Use a 3/32" drill
ERNM3001
CARGO HATCH
TEMPLATE
Note: Cargo hatch is only on the
left side behind the rear cockpit.