GREAT PLANES Waco YMF-5 Instruction Manual page 27

and charge lead in the front or rear cockpit floor. Be careful
to choose a place where the switch will not interfere with the
servos or pushrods underneath. Note: If you will be installing a
pilot figure, temporarily fit the pilot figure to the cockpit so that
you know where to position the switch and charge jack.
❏
3. Glue the switch mounting plate to the back side of the
cockpit floor and install the switch and charge jack.
❏
4. Install a 21" [533mm] Y-harness (HCAM2500) for the
top wing ailerons. Fit the male plug through the rectangular
access hole in the fuselage by the left cabane strut. Use two
small 4" [102mm] tie wraps to secure the harness to the strut.
Cut the hook and loop material
to the correct length and join
the pieces together to make a strap.
1-1/2" [38mm]
"HOOK" SIDE
❏
5. Cut a 5" [127mm] piece of hook and loop material.
Separate the hook side from the loop side and rejoin them
so that 1-1/2" [38mm] overlaps in the middle to make a
battery strap. Make a second strap for your receiver using a
4" [102mm] piece of hook and loop material.
"LOOP" SIDE
27
❏
6. Plug another Y-harness into the aileron channel of
your receiver for the lower wing ailerons. Wrap the receiver
battery pack and your receiver in latex foam rubber. Plug the
elevator, rudder, top wing aileron Y-harness, and throttle into
the receiver. Use the straps you made to attach the battery
pack and the receiver to the battery tray. If you are using
a 2.4GHz radio, route the antennas in a clear location. You
can use a short piece of glow fuel tubing or some remaining
throttle pushrod tube to make short tubes to support and
hold the antennas in position.
❏
7. If you are using a 72MHz radio, route the antenna
through the antenna tube.