Configuring Stored Audio; Uploading A Audio File - American Dynamics ADCI625-P221 Configuration And User's Manual

Select the Output Enable check box to enable the audio output settings. Audio output
3
settings will only be available is audio output is selected.
Or
Deselect the Output Enable check box to disable audio input settings.
The default setting is 'Disabled'.
If Output Enable has been enabled, use the slider bar to select the Output Volume.
4
Values range from 1 to 100.
The default setting is 80.

Configuring Stored Audio

When connected to an appropriate device, the dome is capable of playing back stored audio when
an alarm has been triggered. A maximum of three audio files can be uploaded to the dome.
Note
Audio clips can only be used if a microSD Card has been installed. Refer to the relevant Quick
Reference Guide for information on installing the microSD Card.
When uploading an audio file it must meet the following requirements:
• The filename cannot contain spaces.
• It must be a 'wav' file with a '.wav' extension.
• A single channel mono file with a bit depth of 16kHz.
• The sample rate must be 8kHz.
• The duration must be no longer than 20 seconds.
Procedure 6-14 Play Stored Audio
Step Action
Select Audio from the Camera Configuration menu.
1
Select the Stored Audio tab.
2
The Stored Audio tab displays.
Select to play back the corresponding audio file.
3

Uploading a Audio File

Upload an audio file to the dome.
- End -
- End -
Camera Configuration Menu
6-71
6