Physical Reboot/Reset Of The Dome; Rebooting The Dome Using The Reboot/Reset Switch - American Dynamics ADCI625-P221 Configuration And User's Manual

Physical Reboot/Reset of the Dome

It is possible for perform a physical reboot or reset to factory defaults using the reset/reboot switch
located on the dome, refer to Figure 7-2 Reset/Reboot Switch on the Dome.
Note
To perform a physical reboot or reset, access is required to the dome itself. If the dome is being
used in an Outdoor Housing or with the Indoor Housing Assembly, refer to the quick start guides
supplied with the products for details on how to remove the bubble and gain access to the dome.

Rebooting the Dome using the Reboot/Reset Switch

Perform a reboot of the dome using the reboot/reset switch.
Procedure 7-22 Reboot the dome using the Reboot/Reset Switch
Step Action
Locate the reset/reboot switch on the dome.
1
Refer to Figure 7-2 Reset/Reboot Switch on the Dome.
Press and hold the reset/reboot switch for at least 10 seconds.
2
Release the reset switch.
3
It may take up to 10 seconds for dome to restart. 

When the dome is restarted it checks its functionality by performing a homing routine
during which the camera pans and then either goes to the start point of the 'apple peel'
pattern or if powered up once before, to the last position in memory. Once the camera
stops, it is online and ready to be accessed and controlled.
Figure 7-2 Reset/Reboot Switch on the Dome
Reset/Reboot Switch
- End -
Networking Menu
7
7-93