Fitzroy Inbuilt Fascia Removal; Canterbury Inbuilt Fascia Removal - Cannon Canterbury CANTIB-SDEEB Instruction Manual

fitzroy inbuilt fasCia reMoVal

1. remove the wire mesh grille by gently lifting it
upwards and then outwards. Similarly remove a fitted
glass kit by also gently lifting it upwards and
then outwards.
2. remove 4 M5 screws fixing the fascia assembly to the
heater body. Bring the bottom of the fascia towards
you gently to partly disengage it from the body of the
heater. After it has been disengaged gently lift it up
vertically to completely disengage it from the body of
the heater. refer FIG 8 & FIG 9.
Inner Glass Removal For Both FITZIB & CANTIB
To remove the inner glass loosen off all the clamp screws
and completely remove the one vertical side.
Try not to touch the front surface of the glass. To avoid
finger marks use suitable cloth. remove the glass by
sliding the glass sideways out of the clamp and then
lifting out from the bottom. Place the glass in a safe
position for refit later.

Canterbury inbuilt fasCia reMoVal

1. To remove the inner fascia assembly undo two
screws in the upper flange as indicated in FIG 10.
remove the inner fascia assembly by holding the
glass surround and firmly pull it towards you. refer
FIG 11.
2. remove the lower front cover by unscrewing two M5
screws through the air intake slots. refer FIG 12 unit
is fitted with electronic swtiches ensure that the cable
cannot be trapped when the heater is installed.
3. To remove the front heater surround undo two screws
(one either side) from the bottom flange of
the front panel as indicated in FIG 13.
fig 10
fig 13
to fully remove the
fascia, unclip the switch
cable from the cable
connector on the PCb
and unclip the cable from
the clipping points on
the rear of the fascia.
4. remove the surround by pulling the lower section
towards you gently to partly disengage it from the
body of the heater, then gently lift it vertically to
completely disengage it. refer FIG 14.
5. To fully remove the fascia, unclip the switch cable
from the PCB connector and unclip the cable from
the clipping points. The cable is routed through a
plastic grommet which will have to be removed from
the base plate. refer FIG 15.
fig 11
fig 14
fig 12
grommet
Grommet
fig 15
Cannon Fitzroy / Canterbury Inbuilt | 13
fig 8
fig 9