Toyota SIENNA 2011 Quick Reference Manual page 74

1-2. Operating the AUTO ACCESS SEAT
Returning the AUTO ACCESS SEAT to the vehicle
STEP 1
Park the vehicle on a flat surface and leave the engine run-
ning.
STEP 2
Shift the shift lever to P and set the parking brake.
STEP 3
Confirm the following:
• The right-hand sliding door is fully open.
• The occupant is sitting correctly in the AUTO ACCESS
SEAT. (→P. 14)
• The occupant of the right-hand third seat is safe.
• The condition of the AUTO ACCESS SEAT (→P. 20)
STEP 4
Fold the front passenger seatback while pulling the seat-
back angle lever. (→P. 20)
STEP 5
Remove the wireless remote control from the AUTO
ACCESS SEAT. (→P. 26)
STEP 6
30
SIENNA AAS_U (OM45460U)
Press and hold the seat raise
switch on the wireless remote
control to rotate and raise the
AUTO ACCESS SEAT.
Operation can also be carried
out by pressing the seat raise/
lower switch. (→P. 35)
I n f o r ma t i o n P r o v i d e d b y :