Toyota SIENNA 2011 Quick Reference Manual page 405

3-1. When you think a malfunction has occurred
STEP 12
STEP 13
STEP 14
56
SIENNA AAS_U (OM45460U)
Turn the bolt with yellow marking
clockwise using the combination
wrench, and slide the seat until
the marks are aligned as shown
in the illustration.
If you are unable to slide the seat
until
because the right edge of the
seat cushion interferes with the
sliding door, carry out
and
until the marks are aligned as
shown in the illustration.
Use the combination wrench to
loosen the two bolts, then slide
the motor out of the way and dis-
connect it from the gear.
Rotate the seat into a position
which does not cause the left
edge of the seat cushion to make
contact with the vehicle body.
I n f o r ma t i o n P r o v i d e d b y :
the marks are aligned
STEP
STEP 14
and slide the seat
13