Toyota SIENNA 2011 Quick Reference Manual page 110

■
Setting and canceling the functions
To switch between set and canceled, follow the procedure below:
Vehicles without a smart key system
STEP 1
Close all the doors and turn the engine switch to the "ON"
position. (Perform step 2 within 10 seconds.)
Vehicles with a smart key system
Close all the doors and turn the "ENGINE START STOP"
switch to IGNITION ON mode. (Perform step 2 within 10 sec-
onds.)
STEP 2
Function
Shift position linked door lock-
ing function
Shift position linked door
unlocking function
Speed linked door locking func-
tion
Driver's door linked door unlock-
ing function
When the setting or canceling operation is complete, all doors are
locked and then unlocked.
1-2. Opening, closing and locking the doors
Shift the shift lever to P or N, and
press and hold the door lock
switch (
mately 5 seconds and then
release.
The shift lever and switch posi-
tions
desired function to be set are
shown in the following table.
Use the same procedure to can-
cel the function.
Shift lever
position
P
N
I n f o r ma t i o n P r o v i d e d b y :
or
) for approxi-
corresponding to
Door lock switch
position
1
the
63