Toyota SIENNA 2011 Quick Reference Manual page 408

3-1. When you think a malfunction has occurred
Wireless remote control
If you suspect that the wireless remote control is malfunctioning, try
the correction procedures listed in the table below.
If the seat still does not operate even after trying the procedures, it is
likely that the wireless remote control is malfunctioning. Use the
seat raise/lower switch to operate the AUTO ACCESS SEAT (→P. 35),
and have the wireless remote control inspected by your Toyota
dealer immediately.
If the AUTO ACCESS SEAT does not move
The wireless remote control is too far
away from the vehicle.
Electromagnetic waves in the sur-
rounding area may cause the wire-
less remote control to stop operating.
The battery of the wireless remote
control is discharged.
The switch is being pressed repeat-
edly.
The temperature of the surrounding
area may cause the wireless remote
control to stop operating.
SIENNA AAS_U (OM45460U)
Reason
I n f o r ma t i o n P r o v i d e d b y :
Correction procedure
Move to within approximately 3.3 ft.
(1 m) of the AUTO ACCESS SEAT
and operate the wireless remote
control.
Change your standing position.
Operate the seat using the seat
raise/lower switch.
Replace the battery. (→P. 40)
Push and hold the switch.
Operate the seat using the seat
raise/lower switch.
3
59