Removing And Refitting The Cover - BESAFE iZi Go Modular i-Size User Manual

12
Using the iZi Go with a pushchair
The iZi Go can be installed on a range of pushchairs. For a complete list
check www.besafe.com
Installation on a pushchair
• Align the stroller adapter housings above the adapters of the
pushchair and push straight down, click! (2x) (19)
Removing from a pushchair
1. Move the carrying handle into carrying position.
2. Push the pushchair release levers up at both sides while lifting the
seat vertically from the pushchair. (20)
3. You can also release the seat from the pushchair by pushing the
release levers beside the carrying handle towards the front of the
car seat. (21)

Removing and refitting the cover

• Do take care when you remove the cover, as re-fitting the cover is
done in reverse.
! Warning: potential misuse
• The child seat MUST NOT be installed in a front
passenger seat WITH AN ACTIVATED AIRBAG.
• The floor support must always be used. Make sure that
the floor support is fully pushed down.
• Make sure the indicators are green before you drive.
Guarantee
• Should this product prove faulty within 24 months of purchase
due to materials or manufacturing fault, except covers and harness
straps, please return it to the original place of purchase.
• The guarantee is only valid when you use your seat appropriately
and with care. Please contact your retailer, they will decide if the
seat will be returned to the manufacturer for repair. Replacement
or return cannot be claimed. The guarantee is not extended
through repair.
• The guarantee expires: when there is no receipt, when defects are
caused by incorrect and improper use, when defects are caused by
abuse, misuse or negligence.
13