Advertisement
12
Removing the seat
1. If the seat is installed in the back seat of the vehicle, push the front
seat of the vehicle forward as much as possible.
2. Move the front brace inwards with the ratchet. (19)
3. Release the ISOfix connectors by pressing the release mechanism
on the ISOfix connectors. (20)
4. Push the switch on each side and push the ISOfix connectors into
the base. (21)
5. Pull the seat back towards the front. Turn the seat so you can easily
remove the seat.
6. Remove the insertion clips from the vehicle. Place them under the
base of the child seat.
7. To remove the front brace from the metal tube, move the front
brace outwards with the rachet, until the lock button of the front
brace appears. Push the lock button down with a small screw
driver, while pulling the front brace out. (22)
Positioning of the child
1. Check that the shoulder strap slots are level with your child's
shoulders. (23)
2. The height of the shoulder straps and the head rest can be adjusted
by pulling the release handle upwards at the back of the head rest
and pulling the head rest up or down while keeping the head rest
upright. (24)
3. Pull the shoulder straps up while pressing the button of the central
adjuster. (25)
4. Open the harness buckle. (26)
5. Position the shoulder straps over the orange marking at sides of the
seat to keep the harness open while you position the child. (27)
6. When the child is positioned, place the shoulder straps over the
child's shoulders and close the buckle: CLICK! (28)
7. Pull the harness strap through the central adjuster in the direction of
the arrow straight up/forwards. Continue pulling until the harness is
a comfortable but firm fit. (29)
Sleeping position
• The seat has 3 positions.
• By pulling the recline lever upwards, the seat can be adjusted into
another position. (30)
Removing and refitting the cover
• Do take care when you remove the cover, as re-fitting the cover is
done in reverse.
• Start taking off the lower seat part. (31)
• The cover of the head rest can be taken off separately by
disconnecting the hooks at the back and pulling off the fabric
towards the front.
Refit the cover
• Pull the head rest in the highest position. Replace the head rest cover
and reconnect the hooks at the back side. Pull the harness straps
through the holes. Connect the loose lower part of the head rest
fabric with the plastic part below the head rest.
• Refit the top part and then the shoulder parts. Refit the seat part and
bring the seat cover under the rear parts of the sidewalls.
! Warning: potential misuse
• The child seat MUST NOT be installed in a front
passenger seat WITH AN ACTIVATED AIRBAG.
• The floor support must always be used. Make sure that
the floor support is fully pushed down.
• DO NOT use the seat without tightening the front brace.
• Make sure the indicators are green before you drive.
Guarantee
• Should this product prove faulty within 24 months of purchase
due to materials or manufacturing fault, except covers and harness
straps, please return it to the original place of purchase.
• The guarantee is only valid when you use your seat appropriately and
with care. Please contact your retailer, they will decide if the seat will
be returned to the manufacturer for repair. Replacement or return
cannot be claimed. The guarantee is not extended through repair.
• The guarantee expires: when there is no receipt, when defects are
caused by incorrect and improper use, when defects are caused by
abuse, misuse or negligence.
13
Advertisement
