Using The Extended Control Panel (Sb880E And Sb885E Only) - Smarttech Smart Board 800 series User Manual

CHAPTER 4
USING AND MAINTAINING THE INTERACTIVE WHITEBOARD
The following table shows the Ready light's normal states.
Ready Light State
Solid red
Flashing green
Solid green
Flashing amber

Using the Extended Control Panel (SB880E and SB885E only)

The SB880E and SB885E interactive whiteboards feature an Extended Control Panel (ECP). The
ECP gives you control of the interactive whiteboards's basic operations. Press the Power
button on the ECP to put the projector into Standby mode or to turn it on. Press the ECP's Input
button to switch sources on the projector.
IMPORTANT
Do not disconnect cables from the ECP to connect peripheral devices because you could
disconnect controls for the interactive whiteboard.
24 smarttech.com/kb/144817
Meaning
Your interactive whiteboard is receiving power from the power cable,
but isn't communicating with a computer.
Your interactive whiteboard is receiving power and is communicating
successfully with your computer's USB HID driver.
SMART Product Drivers isn't installed.
NOTE
In HID mode, interactive whiteboard tools such as the pens and the
eraser don't work, but you can move the mouse pointer and perform
mouse functions by touching the interactive surface. The Right-click
button on the pen tray might work, depending on the version of
operating system you're using. Neither the Keyboard nor the Help
button work in HID mode.
Your interactive whiteboard is receiving power and is communicating
successfully with SMART Product Drivers.
The controller module is in a service mode or the firmware is being
updated.