Control Panel; Menu Navigation; Address Selection - Martin MX-10 User Manual

C
ONTROL
You set the address and personalities, read out data, and execute service utilities from the control panel. Settings can
also be changed remotely via the serial link with the Martin MP-2 uploader.
See also the control menu table starting on page 26.

Menu navigation

The DMX address and any error messages are displayed after the fixture resets. To enter the menu, press [menu]. Use
the [up] and [down] keys to move within the menu. To select a function or submenu, press [enter]. To escape a function
or menu, press [menu].
AddR

Address selection

The MX-10 requires 13 channels for DMX control. The address, also known as the start channel, is the first channel
used to receive instructions from the controller. For independent control, each fixture must be assigned its own address
and non-overlapping control channels. Two MX-10s can share the same address if they are to respond identically: they
will receive the same instructions and individual control will not be possible.
T O S E T T H E D M X A D D R E S S
1 Apply power to the MX-10. Press [menu] to enter the main menu.
2 Select AddR using the [up] and [down] keys. Press [enter].
3 Select an address (start channel) from 1 to 500 using the [up] and [down] keys. Press [enter]. Press [menu]
to return to the main menu.
P
ANEL
PATI PTSP PERS
SWAP NORM dISP
PINV PINV FAST dINT
TINV dLOF
dRES
ALON
SCUT
Address/
Messages
dFSE INFO dMXL
FACT TIME
RATE
HRS
qUAL
L HR
L ST
STCO
VER
SHUT
EFSP
Figure 4: MX-10 menu

Control Panel

MAN TSEQ
RST RUN
L ON
LoFF
SHUT
dIM
....
COL
GOBO
I/S
PRIS
RPRI
FOC
PAN
TILT
UTIL
EFFb
AdJ
CAL
dFOF
PCbT
UPLd
11