Lubrication; Replacing Fuses - Martin MX-10 User Manual

4 Dry with a clean, soft and lint-free cloth or blow dry with compressed air.
F A N
To maintain adequate cooling it is important that the fan be
cleaned regularly.
1 Remove the fan by pulling out the locking pins on each
side.
2 Clean with a soft brush, vacuum, or compressed air.
3 Place the fan back in position and press in the locking pins
to secure.

Lubrication

Use only silicone lubricant, Martin P/N 37302003 (500 ml) or P/N 37302004 (200 ml, in applicator bottle). No other
lubricant is approved for use. When applying lubricant, always remove excess and do not get oil on other parts.
1 Check the focus mechanism and apply a drop of lubricant to the 3 metal slides if movement is rough.
2 Lubricate the rotating-gobo bearings if movement is rough on slow rotation or if they become noisy. Apply a
few drops of oil to each bearing from the lamp side of the wheel.

Replacing fuses

M A I N F U S E
The main fuse holder is built in to the mains input socket.
Never replace the fuse with one of a different rating!
1 Unplug the mains cable from the input socket.
2 Pry open the fuse holder and remove the fuse.
3 Replace the fuse with one of the same type and rating.
The fuse rating is listed on serial number label.
4 Close the fuse holder and replace the mains cable.
P O W E R S U P P L Y F U S E S
There are two fuses for the low-voltage power supplies located on the printed circuit board. If one or more of the green
LEDs on the PCB does not light, one of these fuses may be blown. If all three LEDs are lit, the low-voltage power
supplies are functioning correctly.
Have the fixture serviced by a Martin service technician if the
problem persists.
1 Disconnect the fixture from AC power.
2 Remove the front cover.
3 Remove the four screws that fasten the control panel
assembly. Move the display assembly out of the way to
access the PCB.
4 Carefully remove and check the two fuses located in the
top-left corner of the PCB (see page 31). Replace as
necessary with fuses of the same size and rating (see
page 32).
5 Install the control panel and the front cover.
AC input & fuse holder
Data input
Data output
Service 21