Setting The Mcu - Panasonic KX-VC1600SX User Manual

Contacts and Settings
"Quality of Service": Use [
between prioritising sound or images when
bandwidth is low or the network is congested.
–
"Audio" (default): When bandwidth is low
sound quality is prioritised, and when the
network is congested sound disturbance is
reduced.
–
"Video": Even when bandwidth is low or the
network is congested, image quality is
prioritised.
"Default MIC Mute set": Use [
whether to mute the microphone(s) at the start of a
received video conference call.
–
"ON": Mutes the microphone(s).
–
"OFF" (default): Does not mute the
microphone(s).
"Call Limit time": Enter the maximum length of
time for the duration of a video conference call (in
hours and minutes).
Note
•
If you set 0 hours 0 minutes (default), the
call time is unlimited.
•
If the duration of a video conference call
exceeds the specified length of time, the call
will be automatically disconnected.
"Network Connection Status": Use [
select whether to display the network status
indication.
–
"ON" (default): Displays the network status
indication.
–
"OFF": Hides the network status indication.
"Active call Menu": Use [
to display the guide when a video conference call
begins.
–
"ON" (default): Displays the guide.
–
"OFF": Hides the guide.
"Noise reduction": Use [
to enable noise reduction when a video conference
call begins.
–
"ON": Enables noise reduction.
–
"OFF" (default): Disables noise reduction.
"Server Port": Press [ENTER] and use [
select the port to use when connecting using NAT
Traversal Mode.
–
"Default" (default): A normally-used port will be
automatically selected.
–
"Alternate": Set when communication cannot
be performed normally.
102 User Manual
][ ] to select
][ ] to select
][ ] to
][ ] to select whether
][ ] to select whether
][ ] to
Note
•
Displayed when "Connection mode" is set
to "NAT Traversal Mode" or "IP / NAT
Traversal Mode".
3.
Press [G].
•
A dialogue box to confirm the saving of settings
is displayed.
4.
Use [ ][ ] to select "Yes" and press [ENTER].
•
The system settings screen is displayed.

Setting the MCU

1.
Select "MCU Settings" and press [ENTER].
•
The settings screen of the built-in MCU is
displayed.
2.
Use [ ][ ] to select the following items for input:
•
The following items are displayed over 2 pages.
To view all the items, press [R] to move to the
next page, and press [B] to move to the
previous page.
"Screen Layout": Press [ENTER] and use [
[ ] to select the screen layout.
–
"Auto" (default): Automatically changes the
layout depending on the number of parties
joining a video conference call.
–
"CP1-CP10": Sets the screen layout manually.
Note
•
When "Auto" is selected, the layout
changes automatically depending on the
number of sites joining the conference.
Number of Sites
1–2
3–4
5–6
7–8
9–10
•
The screen layout during a conference call can
be selected from the following 6 patterns. The
numbers in the layout configurations indicate
each site's image display priority.
]
Layout Number
CP1
CP4
CP6
CP8
CP10
Document Version 2015-03