Panasonic KX-VC1600SX User Manual page 166

Additional Information
Message
Invalid SIP Server Address.
Invalid SIP Domain Name.
Invalid WAN IP Address.
Invalid Gatekeeper Address.
Failed to save data.
Invalid Operation. Initial
setting is not completed.
System Error! Please restart
the system. If error message
appears again, please
contact Installer or Service
Administrator. * System may
restart automatically.
166 User Manual
•
The format of the SIP server address that you entered is invalid.
→
Enter the SIP server address correctly, in the format
XXX.XXX.XXX.XXX (decimal values separated by periods). For values
of only 1 or 2 digits, enter these numbers as they are. Do not enter like
[.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
Multicast or broadcast addresses cannot be used.
•
The format of the SIP domain name that you entered is invalid.
→
Enter a standards-compliant value. For details, contact your network
administrator.
•
The format of the router's WAN IP address that you entered is invalid.
→
Enter the WAN IP address correctly, in the format XXX.XXX.XXX.XXX
(decimal values separated by periods). For values of only 1 or 2 digits,
enter these numbers as they are. Do not enter like [.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
Multicast or broadcast addresses cannot be used.
•
The format of the gatekeeper's IP address that you entered is invalid.
→
Enter the gatekeeper IP address correctly, in the format
XXX.XXX.XXX.XXX (decimal values separated by periods). For values
of only 1 or 2 digits, enter these numbers as they are. Do not enter like
[.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
Multicast or broadcast addresses cannot be used.
•
You are using a USB memory device that is not compatible with the
unit.
→
Use a USB memory device compatible with the unit (Page 126).
•
There is not enough free space on the USB memory device you are
using.
→
Confirm the USB memory device has sufficient free space (at least
50 MB) before using it.
•
In local site settings, you tried to select and save a connection mode
without completing network settings.
→
Before making local site settings, change the connection mode
(Page 116) and make network settings (Page 99).
•
The unit's internal software failed to start up.
•
The unit failed to write data to the internal flash memory.
→
If the unit does not restart automatically after 20 seconds, restart the
unit by turning off its power, then turning it back on. If the same message
is displayed after resetting the unit, contact your dealer.
Cause and Solution
Document Version 2015-03