Table of Contents
Advertisement
If you do not have a DHCP server, get an IP
address and subnet mask from your network
administrator, type it into the area provided, and
click on Next.
13 Click on Launch Browser.
Your browser points to the ATTO ExpressNAV
splash screen. If you use Internet Explorer as a
browser, you may continue on to the optional
Internet Explorer setup
to
Begin initial configuration
Internet Explorer setup
1
Open your browser
2
Go to the browser toolbar and select Tools.
3
Select Internet Options.
4
In the Internet Options screen, select the
Security tab.
5
Click on the Trusted Sites icon.
6
Click on the Sites button.
7
Uncheck the Require server verification
check box.
8
In the text box Add this web site to the zone,
add the IP address of the appliance. You may
use wild cards.
9
Click Close.
10 At the bottom of the Internet Options dialog,
click OK.
Begin initial configuration
1
The ExpressNAV interface welcome screen
appears. Click on Enter Here.
2
Type in the user name and password.
Note
The default values are user name root and
password Password. The user name is case
insensitive and the password is case
Exhibit 2.0-3 FibreBridge 7500, LEDs, power receptacle and ports
below. If not, continue on
.
sensitive.It is best practice to change the
default user name and password. Refer to
Modify passwords
3
The ExpressNAV FibreBridge status page
appears. Continue to
Exhibit 2.0-1 Brackets to install the FibreBridge
7500 into a rack.
Exhibit 2.0-2 Brackets to install the FibreBridge
7500 into a rack.
on page 7.
Map Devices
on page 8.
5
Advertisement
Table of Contents
