ATTO Technology FibreBridge 7500 Installation And Operation Manual page 30

OpTempWarn
Regulates/displays the number of degrees in Celsius before a
warning is sent to the user. Valid entries are between 0 degrees
and 15 degrees.
Default: 10
set OpTempWarn [0-15]
Requires a SaveConfiguration Restart command
get OpTempWarn
Password
Specifies password for all non-serial sessions: Telnet, FTP and
ExpressNAV interface. You are prompted for the current
password, to enter the new password, and to confirm the new
password. If local Echo is enabled, password echoes all *
characters. If VerboseMode
that you re-enter the password. When the password is all 0s,
Telnet and FTP do not validate the password and MD5
authentication is disabled.Configure an empty password by
pressing the Enter key when prompted for the new password
and the new password confirmation.Passwords are case
sensitive and can be 1-32 characters long with no spaces.
Default: Password
set Password
Requires a SaveConfiguration command
Performance
Returns system performance data. Data consists of the average
rate (MB/s) and number of I/Os (IO/s) measured over the
previous sampling period (approximately one second).
Successful SCSI Read (28h, 88h, A8h) and Write (2Ah, 8Ah,
AAh) commands are considered I/Os. Factors that may affect
reported performance include port availability and saturation,
transfer size, target device speeds, and overall system
utilization.
get Performance
Ping
Sends an ICMP echo request to the specified host.
Ping [mp[n] [IP Address] <count <size>>
ReadOnlyPassword
Specifies password for all non-serial sessions: Telnet, FTP and
ExpressNAV interface. ReadOnlyPassword is case sensitive, 0
to 32 characters, and cannot contain spaces. Configure an
empty password by not specifying one.
Default: Password
set ReadOnlyPassword
Requires a SaveConfiguration command
has been enabled, CLI requests
ReadOnlyUsername
Specifies user name for all Telnet, FTP and ExpressNAV user
management console sessions. Username is case
insensitive, 1-32 characters, no spaces.
Default: User
set ReadOnlyUsername
Requires a SaveConfiguration command
get ReadOnlyUsername
Reserve
Prevents other CLI sessions from modifying the FibreBridge.
When the FibreBridge services interface is reserved, set
commands are unavailable but get commands are available. At
least one service interface always has access to the
FibreBridge at all times. This interface always reports
RELEASED status, since it may issue set commands.
Reservation of the FibreBridge is implicit: if the configuration is
changed by any user of CLI sessions, the FibreBridge becomes
RESERVED. Executing a SaveConfiguration command,
RestoreConfiguration or FirmwareRestart forced
releases the FibreBridge so that other devices may modify it.
Reserve
ResetFCPortErrors
Resets all FC error counts for the specified port to zero. Refer to
FCPortErrors command.
ResetFCPortErrors [fp | all]
RestoreConfiguration
Restores configuration to either the default configuration or the
configuration last saved into non-volatile memory. The saved
option undoes any changes made since the last save.
RestoreConfiguration [Default | Saved | Factory]
RouteDisplay
Displays a list of Fibre Channel to SCSI address mappings on
the FibreBridge.
RouteDisplay FC <fp> <lun>
SASConnectorInfo
SASConnectorInfo displays information about the specified
SAS connector. Valid connector names are A through D.
get SASConnectorInfo [sasConn | all]
SASEnclosures
Displays a list of all attached SMP-based enclosures. If the
optional enclosure index is specified, it displays the drives in the
specified enclosure.
SASEnclosures <n>
x