Table of Contents
Advertisement
Appendix C
The equipment described in this manual generates and uses radio frequency energy. If this equipment is not used
in strict accordance with the manufacturer's instruction, it can and may cause interference with radio and
television reception.
Regulatory Notices
FCC Notices (US only)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: • Reorient or
relocate the receiving antenna. • Increase the separation between the equipment and receiver. •
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. • Consult the dealer or an experienced radio/TV technician for help. Modifications not
expressly approved by the manufacturer could void the user's authority to operated the equipment
under FCC rules.
Compliance with ICES-003
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Compliance with EN Regulations
Marking by the symbol
Voltage Directive of the European Union.
The ATTO FibreBridge 7500 complies with Directive 2011/65/EC on the Restriction of the
Use of Hazardous Substances in Electrical and Electronic Equipment RoHS2 (recast)
and take the following exemptions:
6(c)- Copper allot containing up to 4% lead by weight.
7(a) -Lead in high melting temperature type solders (i.e. lead based alloys containing
85% by weight or more lead).
7(c)-l -Electrical and electronic components containing lead in a glass or ceramic other
than dielectric ceramic in capacitors, e.g. piezoelectronic devices, or in glass or ceramic
matrix compound.
15 - Lead in solders to complete a viable electrical connection between semiconductor die and carrier within
integrated circuit flip chip packages.
Standards and Compliances
indicates compliance of this ATTO device to the EMC Directive and the Low
xiv
Advertisement
Table of Contents
