Table of Contents
Advertisement
If you have not already completed the instructions on the Quick Start page packed with your FibreBridge, use the
following instructions to install the FibreBridge.
Unpack the packing box; verify contents
• The FibreBridge. Note the serial number of your
FibreBridge unit: ________________________
• Power cords
• "L" brackets for mounting in a 19" rack
• Ethernet cable
• RS-232 cable
Install the FibreBridge
1
Place the FibreBridge on a stable flat surface or
install it into a standard rack.
2
If installing into a rack, attach the brackets to
both sides of the FibreBridge enclosure. Then
install the FibreBridge assembly horizontally
within the rack so it does not reduce the air flow
within the rack.
3
Connect the host computer by connecting the
cable to FC port 1 or 2.
4
Connect target devices by connecting SAS
cables to SAS connector A, B, C or D.
5
Power up the target devices.
6
Connect the Ethernet port to your network.
7
Connect the AC power cords from the
FibreBridge to the proper AC source outlets.
Note
Power is automatically supplied to the 7500
when plugged into an AC outlet.
CAUTION
CAUTION
The power source must be connected to a
protective earth ground and comply with
local electrical codes. Improper grounding
may result in an electrical shock or damage
to the unit. Also, be aware that this unit is
powered on once a power source is
connected. Make sure the power supply
module is fully inserted before applying
power. Failure to do so may cause injury or
damage the unit.
4
ATTO Technology Inc. FibreBridge Installation and Operation Manual
2.0 Install the FibreBridge
If you are using a rack:
a. Properly ground the FibreBridge to the rack
equipment. The earth ground connection
must be maintained.
b. The power requirements plus the power
draw of the other equipment in the rack
must not overload the supply circuit and/or
wiring of the rack.
8
Wait for the FibreBridge Ready LED to light,
indicating that the FibreBridge has completed
its power-on self test sequence.
Discover the IP address
Note
The FibreBridge is initially configured with
DHCP enabled. It is best if you have access to
a DHCP server.
1
Power on your system and log in as a user with
proper administrative privileges from the
computer attached to the FibreBridge Ethernet
port on the same domain.
2
Go to www.attotech.com.
3
Select Downloads from the Support menu.
4
Register or log in if previously registered.
5
Select Storage Controllers from the product
list.
6
Select your model.
7
From the table, find your Operating System.
8
Click on the entry for the QuickNAV utility.
9
Select a download destination and allow the
download to complete. Double-click the
downloaded QuickNAV file to install onto your
operating system.
10 Locate the FibreBridge with the serial number
recorded earlier.
11 Highlight the serial number.
12 Click Next.
If a DHCP server is available on your network,
an address is assigned automatically by the
server. Note the assigned address:
_____________________________________
Advertisement
Table of Contents
