Table of Contents
Advertisement
BridgeModel
BridgeModel reports the specific model and firmware
information to the CLI.
get BridgeModel
BridgeLun
BridgeLun controls the automatic generatrion of a bridge device
at LUN 0. After enabling or disabling the bridge LUN, save
configuration and run AutoMap to re-map all devices.
Default: enabled
set BridgeLUN [enabled | disabled]
Requires a SaveConfiguration Restart command
get BridgeLun
BridgeName
BridgeName provides a descriptive ASCII name assigned to the
unit. This field is used by applications to identify individual units.
The specified name can be up to a maximum of 32 characters.
If the name contains spaces, it must be enclosed in quotation
marks. Unlike other non-immediates, changes to BridgeName
take effect immediately.
Default: " "
set BridgeName [name]
get BridgeName
ClearEventLog
ClearEventLog clears the contents of the event log.
ClearEventLog
CoreDumpInfo
Displays information concerning a core dump stored by a prior
fault.
CoreDumpInfo
DataMoverStats
Displays statistics on aggregate data copied by the Data Mover.
Shows the previous hour and minute. Use "all" to display
statistics over the entire 24 hour period.
Usage: get DataMoverStats [all]
Date
Date sets/displays the current date. The date range is
01/01/2000 to 12/31/2099.
Default: 01/01/2000
set Date [MM] / [DD] / [YYYY]
Requires a SaveConfiguration command
get Date
DeleteAllMaps
Removes all mapped devices from the map table. Upon the
subsequent POST, if no maps are present the default maps will
be loaded.
DeleteAllMaps
Requires a SaveConfiguration command
DisplayInitiators
Displays the FC Port world-wide name of the connected
initiators.
DisplayInitiators
DumpConfiguration
Dumps system's configuration.
DumpConfiguration
DumpEventLog
DumpEventLog can be used to dump the contents of the event
log to an RS-232 or telnet session. With no parameters, the last
2048 entries will be displayed. The optional parameter "all"
specifies all entries will be displayed. An optional numeric
parameter specifies the maximum number of entries to display
from the end of the log.
DumpEventLog <NumEntries | all>
EmailFromAddress
EmailFromAddress configures the email address that this
system will use to talk to the email server. Full email address is
a fully qualified Internet email address, not more than 128
characters long.
set EmailFromAddress [full email address]
get EmailFromAddress
EmailNotify
EmailNotify turns on and off email notification. Default is
disabled.
Default: disabled.
set EmailNotify [enabled | disabled]
get EmailNotify
EmailNotifyAddress
EmailNotifyAddress configures notification addresses. Index is
a number between 1 and 5, inclusive. Full email address is a
fully qualified Internet email address, not more than 128
characters long. The level can be "all", "informational",
"warning", "critical" or "none". This is the minimum level of
severity in order for the event to trigger an email notification.
set EmailNotifyAddress [index] [full email address]
[warning level]
get EmailNotifyAddress <index | all>
vi
Advertisement
Table of Contents
