Table of Contents
Advertisement
location whenever a drive or shelf is added or
removed. This allows maps to remain the same when
shelves or drives need to be swapped out due to
1
If you are not already in the ExpressNAV
interface, type the IP address of your
FibreBridge in a standard browser as found in
Using ExpressNAV System Manager
click Enter Here, type in your user name and
password, and click OK.
2
The Status page appears.
3
From the ExpressNAV main menu, click on the
Mapping menu item on the left side of the
screen.
4
The Mapping page appears. If your storage
supports SMP, the ExpressNAV System
Manager will display mapping information for
your devices.
Note
If your devices do not support SMP you will be
able to use the AutoMap feature to map your
storage devices.
failure and remain consistent during power cycles of
the FibreBridge.
AutoMap devices
1
If you are not already in
the ExpressNAV
on page 14,
interface, type the IP
address of your
FibreBridge in a
standard browser as
found in
ExpressNAV System
Manager
click Enter Here, type in
your user name and
password, and click OK.
2
The Status page
appears.
3
From the ExpressNAV
main menu, click on the
Mapping menu item on the left side of the
screen.
4
The Mapping page appears. Wait for the
automatic scan for devices to complete.
5
Click AutoMap.
All the commands necessary to enable
mapping and the command
SaveConfiguration norestart are performed.
Using
on page 14,
9
Advertisement
Table of Contents
