Table of Contents
Advertisement
FCPortErrors
FCPortErrors displays the number of Fibre Channel errors that
have occurred since the last reboot/power-on or
ResetFCPortErrors
command at the Fibre Channel controller
level.
get FCPortErrors [fp | all]
FCPortList
FCPortList returns a list of available FC ports and their current
status. Valid status values are Up, Down, Failed, Reserved
and Disabled.
FCPortList
FCSCSIBusyStatus
This option controls reporting of either a 'BUSY' or 'QUEUE
FULL' status at a point in time when SCSI commands cannot be
accepted.
set FCSCSIBusyStatus [busy | qfull]
Requires a SaveConfiguration Restart command
get FCSCSIBusyStatus
FCSFPInfo
FCSFPInfo displays information about the specified Fibre
Channel SFP.
get FCSFPInfo [fp | all]
FCWWName
FCWWName reports the World Wide Node Name of the Fibre
Channel interface referenced.
get FCWWName [fp | all]
FirmwareRestart
FirmwareRestart resets and reinitializes the firmware. Use the
'forced' option to override any CLI reservations held by other
sessions.
FirmwareRestart <forced>
FlashImages
FlashImages displays the metadata for software images
currently stored in the Flash device. The optional parameter
"validate" also validates the CRC of the flash images. Note that
the CRC validation causes a multi-second delay.
Usage: FlashImages <validate>
Help
The Help command issued with no parameters displays a list of
available CLI commands. When a CLI Command name is
specified, a command usage string and command description is
presented on the CLI.
Help [command name]
HGAddInitiator
Adds an initiator to an existing Host Group. WWN specifies the
world-wide name of the FC Port to be added to the Host Group;
the CLI command "DisplayInitiators" can be used to display
connected initiators.
HGAddInitiator [HostGroupName] [WWN]
HGAddLUN
Adds a LUN to an existing Host Group. The CLI command
"RouteDisplay FC" can be used to display attached LUNs.
HGAddLUN [HostGroupName] [lun]
HGCreate
Creates a new empty Host Group. HostGroupName is an ASCII
name for the Host Group (32 chars max, no spaces). A
HostGroup will expose specified LUNs to specified initiators. To
add a LUN to a Host Group use the CLI command "HGAddLUN"
and to add a host to a HostGroup use the CLI command
"HGAddInitiator".
HGCreate [HostGroupName]
HGDelete
Deletes an existing Host Group.
HGDelete [HostGroupName | all]
HGDisplay
Displays Host Group status information for the specified Host
Group, or for all Host Groups.
HGDisplay [HostGroupName | all]
HGMapping
Changes the systems ability to expose specific LUNs to specific
initiators or to expose all LUNs to all initiators.
set HGMapping [enabled | disabled]
get HGMapping
HGRemoveInitiator
Deletes an initiator from an existing Host Group. The CLI
command "DisplayInitiators" can be used to display connected
initiators.
HGRemoveInitiator [HostGroupName] [WWN]
HGRemoveLUN
Removes a LUN from an existing Host Group. The CLI
command "RouteDisplay FC" can be used to display attached
LUNs.
HGRemoveLUN [HostGroupName] [lun]
viii
Advertisement
Table of Contents
