ATTO Technology FibreBridge 7500 Installation And Operation Manual page 25

Command
RestoreConfiguration
RouteDisplay
SASConnectorInfo
SASEnclosures
SASMapByTopology
SASPortList
SASTargets
SaveConfiguration
SerialNumber
SerialPortBaudRate
SerialPortEcho
SNMP
SNMPDumpMIB
SNMPExtendedTraps
SNMPTrapAddress
SNMPTraps
SNTP
SNTPServer
StopIdentifyLUN
Temperature
Time
TimeZone
Uptime
Username
VirtualDriveResponse
ZModem
Command explanations
AutoMap
Automap will automatically map a subset of target devices
visible to the firmware to a set of Fibre Channel LUNs. All
previous maps will be deleted.
AutoMap
Requires a SaveConfiguration command
v
ATTO Technology Inc. FibreBridge Installation and Operation Manual
Default Example
restoreconfiguration default
routedisplay fc
get sasconnectorinfo all
sasenclosures 1
setsasmapbytopology enabled
sasportlist
sastargets
saveconfiguration restart
get serialnumber
115200 set serialportbaudrate 19200
enabled get seriallportecho
disabled set SNMP enabled
snmpdumpmib
disabled get snmpextendedtraps
0.0.0.0 none set snmptrapaddress 6 192.42.155.155 all
disabled set snmptraps enabled
enabled get sntp
192.43.244.18 set sntpserver 129.6.15.28
StopIdentifyLUN [lun] ...
get temperature
00:00:00 set time 03:32:30
EST set timezone pst
get uptime
root set username Barbara
set virtualdriveresponse enabled
zmodem receive
BootFibreDelay
BootFibreDelay sets the delay (in seconds) after startup before
enabling the Fibre Channel ports. The value "0" constitutes no
delay.
Default: 0 (no delay)
set BootFibreDelay [0-255]
Requires a SaveConfiguration command
get BootFibreDelay