Cylinder Head Disassembly; Cylinder Head Warpage - Polaris 2005 SPORTSMAN 500 Servise Manual

CYLINDER HEAD
INSPECTION
(A)
1. Thoroughly clean cylinder head (A) surface to
remove all traces of gasket material and carbon.
CAUTION: Use care not to damage sealing
surface.

CYLINDER HEAD WARPAGE

Cylinder Head Warpage Limit:
.002" (.05 mm)
1. Lay a straight edge across the surface of the
cylinder head at several different points and
measure warpage by inserting a feeler gauge
between the straight edge and the cylinder head
surface. If warpage exceeds the service limit,
replace the cylinder head.
CYLINDER HEAD
DISASSEMBLY
WARNING: Wear eye protection or a face shield
during cylinder head disassembly and reassembly.
NOTE: Keep all parts in order with respect to their
location in the cylinder head.
1. Using a valve spring compressor (A), compress
the valve spring and remove the split keeper.
NOTE: To prevent loss of tension, do not
compress the valve spring more than necessary.
2. Remove spring retainer and spring.
NOTE: The valve springs should be positioned with
the tightly wound coils against the cylinder head on
progressively wound springs (A).
3. Push valve out, keeping it in order for reassembly
in the same guide.
4. Measure free length of spring with a Vernier
caliper. Check spring for squareness. Compare
ENGINE
A
A
3.21