ELECTRICAL
3. Unplug headlamp from wiring harness.
C
4. Remove O-Ring (C) from headlight pivot pins.
(Both Sides)
C
5. Pull the headlight housing up to release from the
locking tabs.
6. Lift the adjusting knob up to remove from the
locking tabs.
7. Carefully pull the assembly up and out of pod.
8. Reverse the steps to install the new housing and
reassemble the pod.
10.32
*NOTE: The distance from the headlamp parting line
to the end of the adjustment knob stop is 5 1/8, (13
cm). See illustration.
9. Adjust the headlight aim by turning the adjusting
HIGH BEAM HEADLIGHT
ADJUSTMENT
The headlight beam can be adjusted to any position
desired by turning the adjusting knob located on the
bottom right side of the headlight pod.
Raise
counterclockwise
Lower Headight -- Turn knob clockwise
Both Sides
1. Place the vehicle on a level surface with the
5 1/8"
(13 cm)
knob.
Headlight
--
Turn
Headlight Adjustment Knob
headlight approximately 25' (7.6 m) from a wall.
knob
counter--