MUTOH ValueJet VJ-1604 Quick Reference page 97

No.
2 Is the loading position of the media
correct?
3 Is the roll media set correctly?
4 Are there any foreign materials such as
paper attached to the pressurizing
roller?
5 Is the printer being used in an
environment other than the one
specified, such as in direct sunlight?
6 Are you using folded, torn or rolled
media?
7 Does the media bend?
(2) The media is crumpled during initialization
NOTE NOTE
• If the media is jammed or torn, remove it according to "5.2 When media is jammed".
No.
1 Are you using the recommended
media?
2 Is the loading position of the media
correct?
3 Is the media loaded at an angle?
4 Are there any foreign materials such as
paper attached to the pressurizing
roller?
5 Is the printer used in an environment
other than the one specified, such as
near an air conditioner?
6 Are you using folded, torn or rolled
media?
(3) The wrong media size is set during initialization
No.
1 Are you using the recommended
media?
2 Is the media loaded at an angle?
5 Troubleshooting
Possible cause
Set the media correctly.
Set the roll media correctly.
Clean the pressurizing roller.
Only use the printer in an environment that
is specified for use.
Replace the media.
Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
Possible cause
Use the recommended media.
Set the media correctly.
Set the media straight.
Clean the pressurizing roller.
Only use the printer in an environment that
is specified for use.
Replace the media.
Possible cause
Use the recommended media.
Set the media straight.
VJ-1604 QUICK REFERENCE
Remedy
media
media
inside of the printer
manual
on handling media" in
the Operation Manual
type" in the Operation
Manual
menu" in the
Operation Manual
Remedy
type" in the Operation
Manual
media
media
inside of the printer
manual
on handling media" in
the Operation Manual
Remedy
type" in the Operation
Manual
media
Reference
3.5.2 Setting roll
3.5.1 Loading roll
4.2.2 Cleaning the
Installation
"4.2.2 Cautions
"4.2.1 Media
"5 Panel setup
Reference
"4.2.1 Media
3.5.2 Setting roll
3.5.2 Setting roll
4.2.2 Cleaning the
Installation
"4.2.2 Cautions
Reference
"4.2.1 Media
3.5.2 Setting roll
5-15