Types Of Notifications - Otto Bock B600 Instructions For Use Manual

INFORMATION
In the event of communication problems in the control unit
bus system, the system triggers an emergency stop in
order to prevent any uncontrolled functions.
► Note that after every emergency stop, you have to turn
the power wheelchair control unit on again.
► If the driving function is still not available after turning
the control unit on again, activate pushing mode by
releasing the brake.
► Contact a specialist dealer.
Faults are indicated on the control panel LCD display via the
"Battery Capacity" indicator, on the LCD monitor (if avail­
able) or on the attendant control (if available). The following
table shows the individual notifications as well as the associ­
ated fault sources and possible causes and measures.
If the measures described here do not resolve the faults
completely, contact your specialist dealer. The specialist
dealer is able to read the exact error codes with a handheld
programming device and can perform a targeted system
analysis.
The control unit stores a list of all faults which occur. The
specialist dealer reads this information, for example during a
general overhaul of the power wheelchair. Based on the
saved data the specialist dealer determines future service
and maintenance intervals.
B600

7.4.1 Types of notifications

Warning
A warning indicates a status or malfunction of one or several
components of the power wheelchair. The function of com­
ponents that have no errors is not restricted.
For example, if the connection between the control unit and
seat motor is faulty, this error will only be indicated if the
user attempts to activate the motor. However, the driving
function is still available.
Fault
A fault impairs one or several functions of the power wheel­
chair. The power wheelchair and its functions are not fully
operational until the fault is resolved.
Maintenance/Repair
Ottobock | 83