Install Hose Lines; Installation For Metering Pumps Without Bleed Valve - ProMinent Beta BT4b Operating Instructions Manual

8.1 Install hose lines

8.1.1 Installation for metering pumps without bleed valve

Safety notes
CAUTION!
Warning of feed chemical spraying around
If the pipes are improperly installed, they can come lose or
burst.
– Route all hose lines so they are free from mechanical
stresses and kinks.
– Only use original hoses with the specified hose dimen‐
sions and wall thicknesses.
– To ensure high durability of the connections, only use
clamp rings and hose nozzles that are intended for the
hose diameter in question.
CAUTION!
Danger resulting from rupturing hydraulic components
Hydraulic components can rupture if the maximum permis‐
sible operating pressure is exceeded.
– Always maintain the maximum permissible operating
pressure of all hydraulic components - please refer to
the product specific operating instructions and system
documentation.
– Never allow the metering pump to run against a closed
shut-off device.
– Install a relief valve.
CAUTION!
Hazardous feed chemicals can escape
Hazardous or extremely aggressive feed chemicals can leak
out when using conventional bleeding procedures with
metering pumps.
– Install a bleed line with recirculation into the storage
tank.
CAUTION!
Hazardous feed chemicals can escape
Hazardous or extremely aggressive feed chemicals can leak
out in the event that the metering pump is removed from the
installation.
– Shut-off valves must be installed on the metering pump's
pressure and discharge sides.
CAUTION!
Uncontrolled flowing feed chemicals
Feed chemicals can leak through a stopped metering pump
in the event of back pressure.
– For this purpose, use an injection valve or vacuum
breaker.
Installation, hydraulic
23