Advertisement
Final Assembly
These steps complete the assembly of the 2N2/XX.
[ ]
Install small knobs on the RF Gain, Volume, and RIT control potentiometers and the large knob
on the Tuning potentiometer.
[ ]
Install the 4 rubber feet on the bottom of the case near the corners.
[ ]
Set the case top on the bottom case assembly, engage the latch tabs, and latch the top to the
bottom. Your 2N2/XX should look like the one in this last photo!
Congratulation on the successful built of your NORCAL 2N2/XX. We hope you have enjoyed the
building experience, will use the rig often, and enjoy it for many years.
- Figure 81 -
56
Advertisement
