Advertisement
[ ]
Install Volume control potentiometer R80 (marked A10K) into the front panel from the back
side, put on the washer, and then the hex nut. Tighten the control finger tight, as it needs to be
able to rotate for ease of wiring later on.
[ ]
Repeat the above process with RF Gain control potentiometer R77 (marked A1K)
[ ]
Repeat the above process with RIT control potentiometer R53 (marked B1K)
[ ]
Install the 10-turn Tuning potentiometer R54 by putting the internal tooth lock washer on the
shaft, inserting into the panel from the back side, and then adding the hex nut on the panel front
side . As before, tighten only finger tight so that the control can be rotated for ease of wiring.
The front panel should look like the next two photos.
- Figure 65 -
Front Panel Wiring
In the next steps, the front panel will be wired to the PCB.
[ ]
With the PCB and front panel laying face down and aligned side to side with the PCB, begin by
soldering the wires from the Volume pads to the Volume control potentiometer. Use a pair of
the small supplied knobs under the top edge of the front panel to stabilize it. The Volume
Front View
- Figure 64 -
48
Rear View
- Figure 66 -
Advertisement
