Advertisement
[ ]
Install capacitors C42, C43, C62, C63, C64, C65, C66 and C74.
Your PCB should look like that shown in the next figure.
Test – Apply power to the PCB. Connect an RF probe or oscilloscope to the top of resistor R60.
The RF probe should show an output level of approximately 0.16 volts. On an oscilloscope, the
waveform should approximately match that shown in the next figure.
If a frequency counter is available, connect it to the top of R60 and measure the frequency. The
- Figure 19 -
- Figure 20 -
19
Advertisement
