Advertisement
- Figure 56 -
Set the wired PCB aside for the moment while the case components are assembled.
Case Component Assembly
The case is comprised of a bottom shell, top shell, front panel, and rear panel. The top and bottom
shells are held together by a plastic latch system, allowing the top shell to be easily removed for access
to the inside of the 2N2/XX rig. The front and rear panels contain all of the controls and connectors for
the rig. Pem nuts are used to hold the PCB in the bottom shell and the front and rear panels to the
bottom shell.
The case components are shown in this collection of photos.
- Figure 58 -
- Figure 57 -
45
Advertisement
