Advertisement
[ ]
Following the details shown in the next photograph, solder the green and white wires coming
from the "SPKR" pads to the "Speaker" stereo connector. The white wire is soldered to the left
lug and the green wire to the right lug as viewed from the front.
[ ]
Next, solder the black and white wires coming from the "Key" pads to the "Key" stereo
connector. The white wire is soldered to the left lug and the black wire to the right lug as
viewed from the front.
[ ]
Solder the center conductor of the coax coming from the "ANT" pads to the center pin of the
"Antenna" BNC connector. Solder a short length of solid wire (a discarded component lead) to
the ground lug of the BNC connector. Position this wire to be parallel to the coax shield lead
and cut it to an appropriate length so that it overlaps the shield lead. Solder the coax shield lead
and the ground extension lead together.
[ ]
Finally, solder the red and black wires coming from the "PWR" pads to the "12VDC" coaxial
power connector. The black lead is soldered to the center lug and the red lead is soldered to the
right lug.
[ ]
If you did some lacing of the component leads on the front panel, do the same on the rear panel.
[ ]
Remove the masking tape supports. The rear panel should look as shown in the next photo.
- Figure 78 -
54
Advertisement
