Advertisement
[ ]
TUNE (R54) - Cut 7 inch pieces of wire in colors Red, White, and Green. Strip 1/8 inch of
insulation from each end and carefully tin. Solder the Red wire to the TUNE left pad, the White
wire to the TUNE center pad, and the Green wire to the TUNE right pad.
Your PCB should look like that shown in the next figure.
[ ]
RF Gain (R77) - Cut 4 1/2 inch pieces of wire in colors White, Green, and Black. Strip 1/8 inch
of insulation from each end and carefully tin. Solder the White wire to the RF Gain left pad, the
Green wire to the RF Gain center pad, and the Black wire to the RF Gain right pad.
Your PCB should look like that shown in the next figure.
- Figure 48 -
- Figure 49 -
41
Advertisement
