NORCAL 2N2/XX Assembly Manual page 4

Test - Apply 12 volts to the board. With a DVM or VOM, measure that more than 11.7 volts
appears at the junction of D18 and C87.
Your Measurements/Observations - ______________________________________________
____________________________________________________________________________
Receive Active Power Decoupler
[ ] Install transistor Q21
[ ] Install resistor R96
[ ] Install capacitor C38 matching the polarity markings on the capacitor case with those on the
PCB.
Your PCB should look like that shown in the next figure.
- Figure 2 -
4