Advertisement
[ ]
Install a BNC connector in the hole marked "Antenna". To install this connector, push the
connector through the panel hole, place the wire lug over the back of the connector, put on the
internal tooth lock washer, and follow this with the hex nut. Tighten the assembly with the wire
lug pointing to the left when viewed from the back of the panel. Pry the wire lug up so that it
is oriented at about 60 degrees to the panel surface.
[ ]
Finally, install the coaxial power connector in the hole marked "12VDC". The lugs on this
connector should be oriented so that they are left, down, and right when viewed from the back
of the panel.
When all of the connectors are installed, the rear panel should look like the next two photos.
Rear Panel from Rear
- Figure 76 -
Installing the Rear Panel into Case Bottom Shell
The next several steps will result in the rear panel being wired and screwed into place on the rear of the
bottom case shell.
[ ]
Place the rear panel against the PCB at an angle of about 45 degrees. With the panel held in this
position, tape in place with two strips of masking tape to hold it so that the wires to the rear
panel can be soldered more easily. The next photo shows this setup.
Rear Panel from Front
53
- Figure 77 -
Advertisement
