Advertisement
[ ]
PWR (+12/GND) - Cut 4 1/2 inch pieces of wire in colors Red and Black. Strip 1/8 inch of
insulation from each end and carefully tin. Solder the Red wire to the PWR left pad and the
Black wire to the PWR right pad as viewed from the closest PCB edge.
Your PCB should look like that shown in the next figure.
[ ]
ANT (ANR/GND) - Cut a 3 1/2 inch piece of RG-174 coaxial cable. Strip 5/16 inch of outer
insulation from each end. Carefully unbraid the outer shield using a pointed tool such as a scribe
and twist the strands tightly. Carefully tin the first 1/16 inch of the shield on either end. Strip
1/8 inch of insulation from the inner conductor on each end and carefully tin. Solder the outer
shield to the ANT left pad and the inner conductor to the ANT right pad as viewed from
the closest PCB edge.
Your PCB should look like that shown in the next figure.
- Figure 52 -
- Figure 53 -
43
Advertisement
