Advertisement
[ ]
Next, solder the wires from the RIT pads to the RIT control potentiometer. Use the
photograph as a reference in soldering the correctly colored wire to each potentiometer
terminal.
With all of the wire sets correctly soldered to their respective potentiometers, the PCB-Front Panel
assembly should look like the next photo.
[ ]
This next step is optional, but one that will improve the assembly appearance of the finished rig.
If done at this stage of the assembly, it will be easier. Using wide waxed nylon dental tape or
preferably lacing cable, do some lacing together of the control wires from the various
potentiometers back to the PCB. The arrangement is not critical, except for the Volume control
potentiometer. The lacing should not include this control as there are audio signals on the wires;
the remaining controls only have DC voltages on them. The next photo shows an example of a
suggested lacing method.
- Figure 70 -
- Figure 71 -
50
Advertisement
