The RF probe should show an output level of approximately 0.15 volts. On an oscilloscope, the
waveform should approximately match that shown in the next figure.
Your Measurements/Observations - ______________________________________________
____________________________________________________________________________
VFO Driver
[ ]
Wind transformer T5. Put the 16-turn primary (use red wire, not green wire as shown) and the
3-turn secondary (use green wire, not red as shown) windings on the T37-61 dull gray core
with green dot, as shown in the next figure.
Install it onto the PCB. After it is secured, add the remaining 1-turn secondary winding. When
installed, the toroid will look like that in the next figure.
- Figure 22 -
- Figure 23 -
21