Advertisement
[ ]
Install Q9
[ ]
Install diodes D8, D9 and D10. Note cathode ends (bar) on D8 and D9 so they are installed
correctly. D10 (a MV1662) looks like a transistor with only two leads and has no markings on
it, just colored bands.
[ ]
Install resistors R52, R55, R56, R58, R59 and R60.
[ ]
Install trim potentiometer R78 and control potentiometer R54. R54 is wired using leads from
previously installed components and oriented so that when wired to the PCB, the terminals are
pointing as shown in the next figures.
- Figure 17a -
[ ]
Install polystyrene capacitors C76, and C77. This set of capacitors is mounted "on end"
as shown in the next figure.
- Figure 18 -
18
- Figure 17b -
Advertisement
