About The Configuration Page; Configuring Audio (Optional) - Bosch Autodome IP 4000 HD Software Manual

8 en | Configuration
4
Notice!
Click the Help on this page? link if you need more information.
3.1.3

About the Configuration Page

The Configuration page is used to configure the unit and the application interface.
Making Changes
Each configuration screen shows the current settings. You can change the settings by entering
new values or by selecting a predefined value from a list field.
Not every page has a Set button. Changes to pages without a Set button are set immediately.
If a page does show a Set button, you must click the Set button for a change to take effect.
Caution!
Save each change with the associated Set button.
!
Clicking the Set button saves the settings only in the current field. Changes in any other fields
are ignored.
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
1.
2.
3.2

Configuring Audio (Optional)

Enabling Audio Transmission
To transmit audio via the IP connection, follow these steps:
1.
2.
3.
4.
Activating Audio Reception
To configure audio via the Web browser, follow these steps:
1.
2.
3.
4.
2015.04 | .07 |
Click Set and Reboot. The camera will reset (go through the homing sequence, which
usually takes 30 seconds to complete), and then the LIVE page appears, with updated
video and the new IP address.
Make the desired changes.
Click the Set and Reboot button. The camera reboots and the changed settings are
activated.
Open the LIVE page, and then click the Settings tab.
In the left pane, click Advanced, and then click Web Interface. The Web Interface menu
expands.
Click LIVE Functions. The LIVE Functions page appears.
Click the Transmit Audio radio button to enable for audio.
Open the LIVE page, and then click the Settings tab.
In the left pane, click Advanced Mode, and then click Camera. The Camera menu
expands.
Click Audio. The Audio page appears. The page displays the current video image in the
small window next to the slide controls to help you verify the audio source and improve
the Peak levels.
Select the protocol in the Audio field to activate audio over IP. (Change the option to
ON.)
Software Manual
AUTODOME IP 4000 HD / AUTODOME
IP 5000 HD / AUTODOME IP 5000 IR
Bosch Security Systems