Ptz Settings - Bosch Autodome IP 4000 HD Software Manual

AUTODOME IP 4000 HD / AUTODOME
IP 5000 HD / AUTODOME IP 5000 IR
6.12

PTZ Settings

Auto pan speed
Continuously pans the camera at a speed between right and left limit settings. Type a value
between 1 and 60 (expressed in degrees), inclusive. The default setting is 30.
Inactivity
Selects the time period the dome must be not controlled until the inactivity event will be
executed.
–
–
–
Inactivity period
Determines the behavior of the dome when the control for dome is inactive. Select a time
period from the pull-down list (3 sec. - 10 min.). The default setting is 2 minutes.
Auto pivot
The Auto pivot tilts the camera through the vertical position as the camera is rotated to
maintain the correct orientation of the image. Set the Auto Pivot to On (default) to
automatically rotate the camera 180º when following a subject traveling directly beneath the
camera. To disable this feature, click Off.
Freeze frame
Select On to freeze the image while the camera moves to a predetermined scene position.
Turbo mode
Select On to set the camera in Turbo mode when an operator pans or tilts the camera
manually. In this mode, the camera can pan at a maximum of 400° per second, and tilt at a
maximum of 300° per second.
Azimuth
Select On to display azimuth/elevation readings.
Select Off to hide azimuth/elevation readings.
Proportional speed
Select On to increase Proportional speed.
Select Off to decrease Proportional speed.
Proportional speed mode
Options are Super Slow, Slow, Medium, and Fast.
Tilt up limit
Sets the upper tilt limit of the camera. Use the preview window to move the camera to the tilt
limit and click the button.
Tour A / Tour B
Starts and stops the recording of a recorded (guard) tour.
The camera can make up to two (2) recorded tours. A recorded tour saves all manual camera
movements made during the recording, including its rate of pan, tilt and zoom speeds, and
other lens setting changes. The tour does not capture camera video during the recording of
the tour.
Note 1: You can save a total of 15 minutes of recorded actions between the two tours.
To record a tour:
1.
2.
3.
4.
Bosch Security Systems
Off (default): camera remains on a current scene indefinitely.
Scene 1: camera returns to Preset 1.
Previous Aux: camera returns to the previous activity.
Click the Start Recording button. The system prompts you to overwrite the existing tour.
Click Yes to overwrite the existing tour movements.
Click the View Control link, under the image cameo, to access the directional and zoom
controls.
Use the View Control dialog box to make the necessary camera movements.
Software Manual
Camera | en 27
2015.04 | .07 |