Scenes And Tours - Bosch Autodome IP 4000 HD Software Manual

28 en | Camera
5.
Compass
The camera allows a user to display the compass heading of the camera in the lower-right
corner of the image display. The camera displays the cardinal or intercardinal (N, NE, E, SE, S,
SW, W, NW) heading in which the camera is pointing.
Notice!
The compass feature is not compatible with Bosch's Intelligent Tracking feature. If Intelligent
Tracking is activated, the camera automatically disables the display of the compass heading.
Once Intelligent Tracking is deactivated, the camera returns the compass heading to the
display.
You must first calibrate the camera to North before the camera displays accurate compass
headings. The camera uses this calibration, usually set to magnetic North, as the zero degree
pan position and as the North compass heading. The camera then displays the compass
heading based on the number of degrees from the North calibration point.
To set the North calibration point:
1.
2.
3.
North point
–
–
6.13

Scenes and Tours

The camera can store up to 256 preset scenes. You can define the individual scenes that
comprise a preposition tour.
You define individual preposition scenes, then use these scenes to define the preposition tour.
The tour starts from the lowest scene number in the tour and progresses sequentially to the
highest scene number in the tour. The tour displays each scene for a specified dwell time
before advancing to the next scene.
By default, all scenes are part of the preposition tour unless removed.
To define and edit an individual scene:
1.
2.
3.
4.
5.
6.
7.
2015.04 | .07 |
Click the Stop Recording button to save all actions.
Determine the North compass heading, then move the camera to that position.
Select the radio button On for the parameter Compass.
Click the button next to North point to set the calibration point.
Click the Set button to overwrite the existing North point. A dialog box appears with the
message, "Overwrite North point?" To confirm, click OK. To cancel, click Cancel.
Click the Clear button to reset the North point to factory defaults. A dialog box appears
with the message, "Reset North point to factory defaults?" To confirm, click OK. To
cancel, click Cancel.
Set the scene in the video image.
– Use the PTZ controls to move the camera into position.
– Using the Live preview window as reference, navigate to the scene that you want to
define as a preposition.
Click the button Add scene ("+") to define the preposition.
Select a number for the scene, from 1 to 256.
Type an optional name for the scene, up to 20 characters long.
Click OK to save the scene to the Scenes list.
To include the scene in a standard tour, select the check box to the left of the field
"Include in standard tour (marked with *)." An asterisk (*) appears to the left of the
scene name in the Scenes list.
For IR cameras only: To add IR light to the scene, select the check box to the left of the
field "IR light (marked with #)".
Software Manual
AUTODOME IP 4000 HD / AUTODOME
IP 5000 HD / AUTODOME IP 5000 IR
Bosch Security Systems