Configuring Preposition Tours; Remapping Aux Commands (Pelco Protocol, Firmware Version 2.10 And Higher); Using The Wiper/Washer (Pelco Protocol) - Bosch MIC550 User Manual

MIC Series 550
To clear a character from a title:
1.
2.
3.
4.
To save a title:
1.
2.
15.5

Configuring Preposition Tours

15.6 Remapping Aux Commands (Pelco Protocol, firmware version
2.10 and higher)
The Pelco protocols (D and P) support 8 different auxiliaries, but do not define what function
each should perform. This feature enables the 8 available auxiliaries to be set to any of the 8
available functions (WASH WIPE, IR Illuminator, Backlight Comp, Alarm Output 1, Alarm
Output 2, Not Set).
By default, the Aux numbers of the functions are mapped as follows in MIC550:
1
2
5
6
7
8
To change a mapping, select the auxiliary number from the 8 available, press right to select,
and then scroll through the available functions using up and down control inputs.
For example, to remap the Aux command for the wiper in the MIC550 camera to match the
number of the Aux command used in an existing installation, follow these steps:
1. Select option one ("WASH WIPE" by default). Set the value to "Not Set."
2. Select option two ("Alarm Output 2" by default). Set the value to "WASH WIPE." The MIC550
camera will now activate the wash/wipe function in response to the Aux 2 command.
15.7

Using the Wiper/Washer (Pelco Protocol)

To activate the washer/wiper in Pelco protocol, follow these steps:
1. From the submenu Wiper Mode in the menu Camera Setup, select "WASH WIPE," and then
exit the menu.
2. Position the camera so that the nozzle of the washer will spray the camera window.
3. Press 62 and then Preset. Press and hold "Preset" for 2 seconds until the text "Scene 62
Stored" appears on the OSD. (See Chapter 9.2: Setting Preset Shots).
Note: If you already have a preset stored at that position, the system prompts you to overwrite
the current scene.
Bosch Security Systems, Inc.
Use the joystick to highlight the Clear OR Position Character prompt.
Move the joystick left or right until the cursor is below the title character that you need to
clear.
Press Focus/Iris to clear the character.
Move the joystick up to bring the cursor back into the character palette.
Use the joystick to highlight the Exit prompt.
Press Focus/Iris to save the title.
WASH WIPE
Alarm Output 2
Not Set
Not Set
Not Set
Not Set
Operation Manual
Common User Commands | en
November 2011 | | F.01U.239.454
59